Blueview BV5000 Spezifikationen PDF herunterladen (Seite 41)

Check Network Settings

While changes to the network settings can be done without restarting the PC, a

quick power down can solve many network problems that can arise during network

setup. With that in mind, power down both the sonar and computer, wait 10

seconds, then power everything up. This can solve network configuration

problems that may have come about. Once everything is back up and running,

open the ProScan software and try to connect to the sonar.

If you were not able to connect to the sonar, go on to the next section “Check

Connectors”

Check Connectors

It is not uncommon for topside connectors to get pulled out of their ports or

subsea connectors to get corroded. Power-down the sonar, and check the

condition and proper seating of all connectors in the system. Once you have

verified condition and proper seating of all connectors, re-power the Sonar, wait

35 seconds, then try to reconnect to the sonar from ProScan software.

If you were not able to connect to the sonar, go on to the next section “Check

Power”

Check Power

If the sonar does not receive the correct DC voltage on the correct pins, it can

not operate properly. Faulty power supplies, tripped breakers, and damaged

cables can all be the source of this problem. The best way to verify proper voltage

is by measuring the voltage at the sonar connector using a multimeter. Refer to

the hardware manual for your specific sonar for detailed connector/pin information

If you were not able to connect to the sonar, go on to the next section “Check

Sonar”

NOTE: The sonar takes up to 35 seconds to boot up, so do not be surprised at

sporadic network connectivity during this boot up process.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Keine Kommentare

Blueview BV5000 Spezifikationen Seite 41